How to pair Bluetooth headphones with Redmi A7 Pro

Get the headphones ready

This guide covers the Redmi A7 Pro documented by Xiaomi Malaysia, using Google's general Android pairing sequence. Regional software labels can differ. Check the headphones' own instructions for their pairing controls.

Pairing mode makes the accessory available for the phone to find. Google recommends checking that the accessory is discoverable and ready to pair, following the instructions supplied with it. A power light alone is not the confirmation I'd rely on; look for the pairing indication described in that manual.

Choose the headphones on the phone

1. With the headphones ready to pair, swipe down from the top of the phone and touch and hold Bluetooth to open its controls. Turn Bluetooth on if needed.

2. Look for Pair new device. Google's guidance says to check Available devices, or More > Refresh, if that label is absent. Follow the options shown on your build.

3. Tap the headphones' name and follow the pairing prompts. Compare it with the name in the accessory instructions so you choose the right device.

Check that the accessory shows as Connected. I'd then play a short piece of audio at a low starting volume and confirm it comes through the headphones. Pairing, an active connection and audible playback are useful separate checkpoints.

If the name is missing or pairing fails

Check the accessory's pairing mode again, refresh the device list and try its name once it appears. Google also recommends turning Bluetooth off and on, confirming the devices are paired and connected, and restarting both devices if problems persist.

I'd note which stage failed before asking for help: the name never appears, the pairing prompt fails, or the saved accessory will not connect. Include the headphone model and the phone's software version. That gives support a clearer starting point than assuming every Bluetooth accessory behaves the same way.

If connected headphones play no music

Google's troubleshooting recommends checking the volume on both the phone and accessory, and whether another paired device is playing the music. In the Bluetooth settings for the headphones, check that Media audio is enabled if your build offers that control.

I'd replay the same short audio clip after each change. This keeps the test simple and makes it easier to tell which check helped. If the controls differ from the general Android instructions, use Xiaomi's help for your software and the accessory maker's support information.

Reconnect later, or remove the pairing

Google explains that paired devices remain saved until you unpair them. To reconnect a saved but disconnected accessory, turn Bluetooth on and select it from the saved-device list. In its device settings, Disconnect ends the connection; Forget removes the saved pairing.

Xiaomi separately says the A7 Pro does not support Bluetooth audio sharing. This guide covers connecting one pair of headphones, not sending the same audio to two sets at once.

If you wanted to send a photo to another Android phone instead, my A7 Pro Quick Share guide covers that different task.